Avoiding Water Pressure Losses In Your Showers

Plumber Goodyear

Any loss in showers water pressure is really an annoyance, even though it’s only a short disruption because of a flushed toilet. Of course it is much worse in case it is a chronic issue which makes it much harder to rinse shampoo and soap away. There are many ways of preventing and fixing this common issue, but they differ depending on their root causes.
Pressure Balancing Valve Limitation
If the shower has pressure balancing valve – in which there is a single handle or knob to control both flow of water and temperature — you’re possibly at the risk of interruption of water pressure because of the usage of other close by fixtures. The classic instance is when any flushing toilet causes a change in water temperature and pressure drop.
This kind of valve mixes cold and hot water together at certain pressure levels. When a toilet flushes, the cold water get diverted to refill tank, which lead to a drop in pressure in the colder water line. It even takes the pressure balancing valve few seconds to adjust itself, during which time water might turn very hot as the valve is not getting all cold water it requires. And then when valve adjust, it does this by decreasing the pressure coming out from hot water line, leading to an overall pressure drop.
Luckily, there’s another kind of shower valve which allows you to prevent this problem completely. It’s known as thermostatic mixing valve, which offers separate control for water pressure and temperature. Call a trusted local plumber to ask regarding upgrading to one among these valves.
The Malfunctioning Diverter Valve
In case you have a shower and bathtub combo, you’ve a diverter valve probably — a switch or knob which diverts water from bathtub faucet to the showerhead. Such valves can break or malfunction after many years of services, and the result can be that valve cannot open sufficiently to send complete water pressure to showerhead.
This likely is a culprit if the water flows from bathtub faucet at complete pressure but fails down to match the pressure from showerhead. A plumber could confirm this diagnosis as well as complete the repairs with replacement diverter valve.
The Water Pressure Reduction Valves Need Adjustment
When the water pressure issue affects all the fixtures inside your home, the main cause could be near to water source. In a few homes, a device known as water pressure reducing valve is linked to main water line close to the point wherein it enters the house. This valve can break, malfunction, or fall outside adjustment — and all these three are jobs best for an expert plumber.
Obstructed or Broken Pipe
The worst probable cause of any shower pressure drop tends to be a broken pipe, as the resulting leakage could do serious damages to an unseen part of your house. If you can ever hear water running where and when it should not be, or in case you suddenly see water or dripping stains, shut your water supply off at main valve and contact Plumber Goodyear for an emergency service immediately.
Clogged Showerhead or Pipe
Conversely, the best scenario is that the showerhead is simply clogged and dirty. To get a closer look, unscrew the showerhead from wall if probable. You may wish to soak it into an apt cleaning solution for many minutes prior to cleaning all nozzles thoroughly with any old toothbrush.
In case you reside in a region with hard water, then you may even have minerals deposit accumulation in your pipes. This decreases flow gradually and eventually will have a very noticeable effect on your water pressure. This issue can be easily avoided with water softening system installation, but pipes which are clogged badly may have to be professionally replaced or cleaned.

Tutorials

24 hour plumberemergency plumberlocal plumber near meplumber near meplumbing servicesplumbing supplies near meplumbing supplyplumbing supply near me

Leave a Reply

Your email address will not be published. Required fields are marked *

Call Now